<img height="1" width="1" style="display:none" src="https://www.facebook.com/tr?id=3043170519342045&amp;ev=PageView&amp;noscript=1">

Test process for common Mini EML warning light fault

Technical articles
POSTED 27 April 2023

Test process for common Mini EML warning light fault


Test process for common Mini EML warning light fault
IVS 360TM brand-specific master technicians at Opus IVS ourline a problem documented for the N12 engine used on 2006 to 2013 second generation Minis.


Faults Presented:

  • Engine management warning light on IPC
  • Fault code 2968 stored in the Digital Motor Electronics (DME) from the inlet camshaft sensor.

Possible Causes:

This fault can have many possible sensor-related causes. These include a faulty part, an incorrect part being fitted, faulty wiring as well as sensor corrosion or damage. It may also indicate a DME internal fault or an inoperative inlet VANOS unit.


IVS 360TM Repair Steps: 

The valve gear on the N12 engine is equipped with variable camshaft timing control for the inlet and exhaust camshafts (also known as double VANOS). Both camshaft sensors record camshaft adjustment, via a sensor wheel fixed to the camshaft.
The camshaft sensor works according to the Hall effect. Voltage is supplied to the sensor by the DME with 5 Volts and ground. The sensor then returns a digital signal via the signal line back to the DME. (Pictured below).

Camshaft sensor

To begin, start by swapping over the inlet camshaft sensor with the exhaust camshaft sensor – they are the exact same part so this is often a very quick task. the fault migrates to the exhaust camshaft then replace the sensor.  (Pictured below).

If the fault stays on the inlet camshaft sensor then proceed to check the wiring. You will need a 5v feed, ground and an intact signal wire between the inlet camshaft sensor and the DME to prove the 5v supply and earth is being provided by the DME. (Pictured below).

Check DME Wiring
Next, check the signal pattern with an oscilloscope. A signal indicates that the sensor is working whilst scoping at the DME end will also check the integrity of the signal line. (Pictured below).

The signals in the image above are correct, from a verified N12 running engine. Both the intake and exhaust camshaft sensors should have an identical scope pattern, just at different positions on the screen.

The IVS 360™ live support team has seen cases where non-OE or used camshafts have been fitted. When doing so, you must make sure the camshaft is an exact match for the part removed.
This image (see Bad-Scope-Trace.jpg) shows the scope trace from an N12 where an incorrect inlet camshaft was fitted. We can see that with this alternative aftermarket part fitted, the inlet camshaft sensor signal has four phases compared to the image on the known good engine with only three.
By scoping the inlet camshaft sensor and exhaust camshaft sensor, along with the crankshaft sensor, the timing of the engine can be checked non-intrusively too using phase rulers and graph rulers as shown. (Pictured below).



How can we help you?

The Opus IVS DrivePro™ Elite Diagnostic Kit offers a remote services VCI and coverage for 64 brands. It also comes with IVS 360™ live diagnostic support included, bringing you complete access to the team of brand-specific OE master technicians.
For even more in-depth solutions, garages can rely upon the pay-as-you-go appointment-based Remote Assist Program (RAP). This brings independent garages enhanced capability to complete a huge range of complex programming and coding jobs on-demand.

Looking for more information?
If you're a garage wishing to find out more please get in touch with us.